
3.4 HW Module Description and Jumper settings
3.4.1 Power Module
EV-board has 4 kinds of power supply for user to choose. Please read below instructions before us-
ing.
? DC Adaptor: 9V DC:
Output voltage: 9V
Connection: Connector (CN6)
? Battery:
QTY: 4PCS;
Model: AA;
Nominal voltage: 1.5V.
Connection: Socket for Battery
? External Power Supply:
There are 2 test points (TP1&2) on EV-board which can supply power to target board (EVboard).
Power on method: short L3 on EV-board; then connect anode of DC power to TP1 (MCU Vcc) and
cathode to TP2 (MCU GND).
? USB cable:
The Mini-B USB receptacle is only for supplying power to EV board by PC USB port. The current
and power of this method is limited in 100mA/0.5W.
Please make sure to supply stable power via the Mini-B USB receptacle while operation.
If any of the power supplies is connected to the EV-board correctly, power LED (LED5) on
the EV-board will be on. Refer to Figure 3.4.1-1.
Figure 3.4.1-1 Power Module
11